[IPP] First draft of IPP Finishings 2.1 available for review
Kennedy, Smith (Wireless Architect)
smith.kennedy at hp.com
Thu Apr 14 20:55:53 UTC 2016
I wasn't sure whether the registrations posted earlier to the reflector were sufficient or if they needed to be included. I will make these changes in the next draft, to be posted hopefully by EOD tomorrow, in preparation for the F2F.
Smith
> On 2016-04-14, at 2:32 PM, Michael Sweet <msweet at apple.com> wrote:
>
> Bill,
>
>> On Apr 14, 2016, at 4:06 PM, wamwagner at comcast.net <mailto:wamwagner at comcast.net> wrote:
>>
>> Hi Smith,
>> My notes indicated that EcoStaple (perhaps as “crimp”) and Engineering Z Fold values would be included in Finishings 2.1, but I do not see them. Am I just missing tem or was there a change of approach?
>
> Yes, I think these should be in there but currently are not.
>
> The changes that are needed are:
>
> 1. Figure 1: Add 'fold-engineering-z' (I owe you this one Smith)
>
> 2. New Section 5.1.x PWG 5100.1-YYYY "finishings Values"
>
> - New "finishings" enum value 101 with keyword name 'fold-engineering-z'
> - "Fold the hardcopy output vertically into three sections, forming a Z but leaving room for binding, punching, or stapling along the top edge."
>
> 3. Section 5.2.6.4 “folding” Examples
>
> `fold-engineering-z’
> folding = { folding-direction=’inward’ folding-offset=11593
> folding-reference-edge=’top’ },
> { folding-direction=’outward’ folding-offset=20646
> folding-reference-edge=’top’ }
>
> 4. New Section 5.2.12.5 stitching-type (type2 keyword)
>
> The "stitching-type" member attribute specifies the type of stitching to use. The following values are defined by this specification:
>
> 'auto': Automatically choose a stitching type based on the Set being finished.
> 'crimp': Crimp the Set together.
> 'wire': Use wire staples.
>
> 5. New Section 6.x stitching-type-supported (1setOf type2 keyword)
>
> The "stitching-type-supported" Printer attribute lists the supported values for the "stitching-type" (section 5.2.12.5) member attribute.
>
>
> Note: JDF has a "stitching type" with values "corner", "saddle", and "side". Perhaps we should use the name "stitching-kind" instead to avoid confusion (since JDF doesn't currently support crimping/eco-staples)???
>
> _________________________________________________________
> Michael Sweet, Senior Printing System Engineer
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pwg.org/pipermail/ipp/attachments/20160414/5df81388/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: smime.p7s
Type: application/pkcs7-signature
Size: 4956 bytes
Desc: not available
URL: <http://www.pwg.org/pipermail/ipp/attachments/20160414/5df81388/attachment.p7s>
More information about the ipp
mailing list